Komatsu · Engine controller
Komatsu Fault Code CA428
Water in fuel sensor: high voltage
What does Komatsu code CA428 mean?
The water-in-fuel sensor in the fuel separator is reporting a voltage above range. It may mean water is present in the fuel, or the sensor or its wiring has failed. Urgency: check soon - the machine may derate or limit a function. Check first: drain the water from the fuel separator and see whether the code clears.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Drain the water from the fuel separator and see whether the code clears
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- Water collected in the fuel separator bowl
- Water sensor wire open or loose
- Sensor failed
- Contaminated fuel from the tank
How it failed
You'll notice: Water in fuel warning with CA428 on the monitor.
Shorted highRead from how the source describes the code
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine fluid, filter and temperature warnings
2 other codes on this part are also shorted high (B@BCNS, B@HANS). When they show together, start at the wiring and connector they share.
- B@BAZGEngine oil pressure lowOtherStop now
- B@BAZKEngine oil level lowOtherCheck soon
- B@BCNSEngine coolant overheatingShorted highStop now
- B@BCZKEngine coolant level lowLost messageCheck soon
- B@HANSHydraulic oil overheatingShorted highStop now
- AA10NXAir filter cloggedReal conditionCheck soon
- CA428Water in fuel sensor: high voltageShorted highCheck soon
- CA429Water in fuel sensor: low voltageShorted lowCheck soon
- CA435Engine oil pressure switch errorOtherCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA428 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
