EF Logo

Komatsu · Engine controller

Komatsu Fault Code B@BCNS

Engine coolant overheating

What does Komatsu code B@BCNS mean?

The engine coolant temperature went above the limit. Keep running and the head can crack or the gasket blow, so stop the engine and let it idle down first. Urgency: stop now - shut down and fix before working on. Check first: let the engine idle to cool, then check the coolant level when it is safe to do so.

FaultStopB@BCNSKomatsu · Engine controller

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Let the engine idle to cool, then check the coolant level when it is safe to do so

Then 3 more checks
Code shows hereFAULTB@BCNS

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 4 done

Causes

  • Low coolant level or leak
  • Blocked radiator or oil cooler fins
  • Fan drive or belt not working
  • Failed thermostat
1 more cause
  • Failed temperature sensor

How it failed

You'll notice: Coolant overheat warning on the monitor with B@BCNS.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine fluid, filter and temperature warnings

Source

Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)

This source lists B@BCNS and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.