Komatsu · Engine controller
Komatsu Fault Code CA115
Engine Ne and Bkup speed sensor error
What does Komatsu code CA115 mean?
The engine controller lost the signal from both the Ne (crankshaft) and the backup (camshaft) speed sensors at the same time. With no speed reference it cannot time the injectors, so the engine will not start or it stops. Urgency: stop now - shut down and fix before working on. Check first: check that both speed sensor connectors are fully locked and free of oil before anything else.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check that both speed sensor connectors are fully locked and free of oil before anything else
Then 5 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 6 done
Causes
- Common ground or shield wire shared by both speed sensors is open
- Both sensor connectors loose, oily or corroded after a wash
- Harness crushed between the engine block and a bracket
- Low sensor supply or an input fault inside the engine controller
How it failed
You'll notice: Engine will not start or stops running, with CA115 on the monitor.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine Ne and backup speed sensors
- CA115Engine Ne and Bkup speed sensor errorOtherStop now
- CA238Ne speed sensor power supply voltage errorOtherCheck soon
- CA689Engine Ne speed sensor errorLost messageCheck soon
- CA731Engine Bkup speed sensor phase errorOtherCheck soon
- CA778Engine Bkup speed sensor errorLost messageCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA115 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
