Komatsu · Engine controller
Komatsu Fault Code CA689
Engine Ne speed sensor error
What does Komatsu code CA689 mean?
The signal from the Ne (crankshaft) speed sensor is lost or erratic. The engine can often keep running on the backup sensor, but starting is slower and a second sensor fault would stop the engine. Urgency: check soon - the machine may derate or limit a function. Check first: unplug the Ne sensor and measure coil resistance, then compare it with the shop manual value.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Unplug the Ne sensor and measure coil resistance, then compare it with the shop manual value
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- Ne sensor connector loose or full of oil
- Sensor tip dirty or air gap changed after a repair
- Ne signal wire open or touching its neighbour
How it failed
You'll notice: Engine starts slowly or runs rough with CA689 on the monitor; it may still run on the backup sensor.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine Ne and backup speed sensors
1 other code on this part is also lost message (CA778). When they show together, start at the wiring and connector they share.
- CA115Engine Ne and Bkup speed sensor errorOtherStop now
- CA238Ne speed sensor power supply voltage errorOtherCheck soon
- CA689Engine Ne speed sensor errorLost messageCheck soon
- CA731Engine Bkup speed sensor phase errorOtherCheck soon
- CA778Engine Bkup speed sensor errorLost messageCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA689 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
