EF Logo

Komatsu · Engine controller

Komatsu Fault Code B@BAZG

Engine oil pressure low

What does Komatsu code B@BAZG mean?

The engine oil pressure is below the allowed value for the speed. Running on may destroy the bearings, so stop the engine. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level and filter condition.

FaultStopB@BAZGKomatsu · Engine controller

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop the engine and check the oil level and filter condition

Then 4 more checks
Code shows hereFAULTB@BAZG

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 5 done

Causes

  • Low engine oil level
  • Worn oil pump or bearings
  • Clogged oil filter
  • Failed oil pressure switch or wiring

How it failed

You'll notice: Oil pressure warning on the monitor with B@BAZG; stop the engine.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine fluid, filter and temperature warnings

Source

Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)

This source lists B@BAZG and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.