EF Logo

Bobcat · Safety interlocks

Bobcat Fault Code M1606

Traction lock hold solenoid short to ground

What does Bobcat code M1606 mean?

The traction lock hold solenoid output is shorted to ground, so the coil will not energise correctly. On excavators the same number refers to the hydraulic bypass. Urgency: check soon - the machine may derate or limit a function. Check first: with the plug off, test the traction lock hold solenoid output wire to chassis ground; a reading near zero shows a harness short to ground.

FaultCheckM1606Bobcat · Safety interlocks

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With the plug off, test the traction lock hold solenoid output wire to chassis ground; a reading near zero shows a harness short to ground

Then 5 more checks
Code shows hereFAULTM1606

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Weak hold stage letting the lock fall back after release
  • Chafed output wire touching the frame at the hold coil of the drive lock valve, behind the pull solenoid
  • Moisture inside the traction lock hold solenoid connector
  • Harness crushed at a bracket or clamp
1 more cause
  • Coil insulation breakdown

How it failed

You'll notice: The traction lock hold solenoid output reads grounded, which stops the controller driving the coil.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Traction lock and hydraulic lock solenoids

4 other codes on this part are also shorted low (16-06, 17-06, C1029-11, M1706). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 Traction lock and hydraulic lock solenoids codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M1606 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders S450-S850 and T450-T870.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.