EF Logo

Bobcat · Safety interlocks

Bobcat Fault Code 17‑07

Hydraulic lock valve solenoid open circuit

What does Bobcat code 17-07 mean?

The controller sees no load on the hydraulic lock valve solenoid circuit, which means the circuit is open. Lift and tilt (or the excavator hydraulics) may stay locked out. Urgency: check soon - the machine may derate or limit a function. Check first: pull the plug and check for a pin that has backed out or a terminal that no longer grips the blade.

FaultCheck17-07Bobcat · Safety interlocks

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Pull the plug and check for a pin that has backed out or a terminal that no longer grips the blade

Then 5 more checks
Code shows hereFAULT17-07

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Coil winding open
  • Pin backed out of the plug
  • Broken wire between the controller and the hydraulic lock valve solenoid
  • Contamination in the lock valve spool bore
1 more cause
  • Plug not fully seated

How it failed

You'll notice: The controller sees no load on the hydraulic lock valve solenoid circuit, so the output is open.

Open circuitRead from how the source describes the code

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Traction lock and hydraulic lock solenoids

5 other codes on this part are also open circuit (16-07, C1029-13, M1507, M1607 and more). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 Traction lock and hydraulic lock solenoids codes on one page

Source

Bobcat S205 Operation & Maintenance Manual, service codes (flash count table)

This source lists 17-07 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Older Bobcat skid-steer and track loaders using the two-digit service codes (S205 manual, similar models).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.