EF Logo

Bobcat · Safety interlocks

Bobcat Fault Code 16‑06

Traction lock hold solenoid short to ground

What does Bobcat code 16-06 mean?

The controller found the traction lock hold solenoid circuit pulled to ground when it should be able to switch it. Urgency: check soon - the machine may derate or limit a function. Check first: check the short harness spur between the hold coil and the main interlock connector, which gets pinched when the cab is tilted for a pinched or chafed spot against the frame or a bracket.

FaultCheck16-06Bobcat · Safety interlocks

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the short harness spur between the hold coil and the main interlock connector, which gets pinched when the cab is tilted for a pinched or chafed spot against the frame or a bracket

Then 5 more checks
Code shows hereFAULT16-06

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Wet or corroded plug giving a path to ground
  • Weak hold stage letting the lock fall back after release
  • Coil shorted to its housing
  • Traction lock hold solenoid output wire rubbed through to ground along the short harness spur between the hold coil and the main interlock connector, which gets pinched when the cab is tilted
1 more cause
  • Harness pinched against a frame bracket

How it failed

You'll notice: The controller found the traction lock hold solenoid output pulled to ground, so the coil cannot be energised.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Traction lock and hydraulic lock solenoids

4 other codes on this part are also shorted low (17-06, C1029-11, M1606, M1706). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 Traction lock and hydraulic lock solenoids codes on one page

Source

Bobcat S205 Operation & Maintenance Manual, service codes (flash count table)

This source lists 16-06 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Older Bobcat skid-steer and track loaders using the two-digit service codes (S205 manual, similar models).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.