EF Logo

John Deere · Engine control unit (ECU) - PowerTech engine

John Deere Fault Code ECU 000097.04

Water in fuel separator full

What does John Deere code ECU 000097.04 mean?

The ECU reports the water in fuel separator is full, meaning water has collected in the fuel system. The operator may see a warning and ignoring it can damage injectors and the high pressure pump. Urgency: check soon - the machine may derate or limit a function. Check first: drain the water separator bowl and watch what comes out; a lot of water means the tank is contaminated.

FaultCheckECU000097.04John Deere · Engine control unit (ECU) - PowerTech engine
ECU
Which controller reports it
.04
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Drain the water separator bowl and watch what comes out; a lot of water means the tank is contaminated

Then 4 more checks
Code shows hereFAULTECU000097.04

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Water collected in the fuel system from condensation or contaminated fuel
  • Separator bowl not drained at the service interval
  • Water getting in through a loose tank cap or a damaged tank vent
  • Poor fuel quality from the supplier

How it failed

You'll notice: The ECU reports that the water in fuel separator is full.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine, overheat, fuel and water alarms on the monitor

7 other codes on this part are also lost message (DSZ 20101.02, ICZ 20101.02, DSZ 20102.02, ICZ 20102.02 and more). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Engine, overheat, fuel and water alarms on the monitor codes on one page

Source

Inside the Yard - John Deere fault codes list (ECU engine codes)

This source lists ECU 000097.04 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere PowerTech engines; code list comes from tractor-based sources, confirm for your machine.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.