EF Logo

J1939 · Fuel system

SPN 97 Fault Code

Water in fuel indicator

What does SPN 97 mean?

On/off state of the water-in-fuel sensor in the filter or water separator bowl. The ECM uses it to warn the driver to drain water before it reaches the injection system. How urgent it is depends on the FMI after SPN 97 - pick it below. Check first: drain the water separator bowl into a clear container and look for water or milky fuel.

FaultActiveSPN 97FMI --J1939 engine ECU
SPN 97
Water in fuel indicator
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 97 - pick it below.

What should I check first?

Drain the water separator bowl into a clear container and look for water or milky fuel

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 97?

You'll notice: The water-in-fuel warning shows on the dash, and the ECM may limit power if the warning is ignored.

Find the number shown after SPN 97 on your display. FMI 16 has its own page with causes and checks.

  • 0SPN 97 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
  • 3SPN 97 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 4SPN 97 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 14SPN 97 FMI 14: The water-in-fuel warning is active and water should be drainedOtherDetroit DD15, Detroit DD13
  • 15SPN 97 FMI 15: Value is above the normal range, least severe levelReal conditionCummins ISX15
  • 16SPN 97 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15
  • 31SPN 97 FMI 31: The water-in-fuel warning has been present and ignored for the ECM's set periodReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5

Checks

0 of 5 done

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

How urgent SPN 97 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Real water in the fuel from condensation in a part-empty tank, a contaminated delivery or a leaking filler cap
  • Water separator bowl full and not drained at its service interval
  • Water-in-fuel sensor in the separator fouled with sludge or fuel residue, giving a false warning
  • Sensor circuit fault: wiring open or shorted, or a connector corroded at the separator

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 97 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.