EF Logo

Bobcat · Engine

Bobcat Fault Code M0409

Engine oil pressure too low

What does Bobcat code M0409 mean?

The engine oil pressure sensor reads lower than the warning level. Watch it closely and fix it before it reaches shutdown. Urgency: check soon - the machine may derate or limit a function. Check first: look at the oil on the dipstick for fuel or coolant smell and thin, watery colour, which would explain low pressure.

FaultCheckM0409Bobcat · Engine

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Look at the oil on the dipstick for fuel or coolant smell and thin, watery colour, which would explain low pressure

Then 3 more checks
Code shows hereFAULTM0409

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Clogged oil filter or relief valve stuck open
  • Worn pump or bearings
  • Failing sensor reading lower than the real pressure
  • Wrong or diluted oil that is too thin when hot

How it failed

You'll notice: The panel shows low engine oil pressure while the engine runs.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine oil pressure, coolant and air temperature

4 other codes on this part are also real condition (M0810, M0811, M0821, M0822). When they show together, start at the wiring and connector they share.

Show the other 19 codes
All 28 Engine oil pressure, coolant and air temperature codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0409 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders S450-S850 and T450-T870.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.