EF Logo

Komatsu · Engine controller

Komatsu Fault Code AB00KE

Charging voltage low

What does Komatsu code AB00KE mean?

The charging system voltage is too low. The battery is discharging, and over time the machine will not start or the controllers may reset. Urgency: check soon - the machine may derate or limit a function. Check first: measure the voltage at the battery with the engine running; it should rise above the resting reading.

FaultCheckAB00KEKomatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the voltage at the battery with the engine running; it should rise above the resting reading

Then 4 more checks
Code shows hereFAULTAB00KE

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 5 done

Causes

  • Alternator not charging
  • Slipping drive belt
  • Loose or corroded battery or alternator cable
  • Battery worn out

How it failed

You'll notice: Battery charge warning with AB00KE on the monitor.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery, charging and air heater

1 other code on this part is also shorted low (CA441). When they show together, start at the wiring and connector they share.

All 5 Battery, charging and air heater codes on one page

Source

Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)

This source lists AB00KE and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.