EF Logo

Deutz · Coolant, oil and fuel sensors

Deutz Fault Code SPN 100 FMI 1

Engine - Oil pressure sensor - Data below normal operational range (Most severe level)

What does Deutz code SPN 100 FMI 1 mean?

The oil pressure sensor (on the engine block or oil filter housing in the main oil gallery) reports a value below the allowed range. This is a plausibility limit, so the low value may be genuine rather than a wiring fault. Urgency: stop now - shut down and fix before working on. Check first: compare with its neighbouring sensors in SerDia to see whether only this value is off.

FaultStopSPN 100FMI 1Deutz · Coolant, oil and fuel sensors
FMI 1
Data below normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Compare with its neighbouring sensors in SerDia to see whether only this value is off

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 4 done

Causes

  • Hose or port feeding the sensor split or disconnected
  • Sensor body cracked or its thread leaking after an oil filter service
  • Oil pressure sensor drifting low or reading with an offset

How it failed

You'll notice: Warning or derate: the oil pressure gauge or lamp misbehaves and the EMR4 protection function can derate or even shut the engine down if it believes pressure is truly lost.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant, oil and low-pressure fuel sensors

8 other codes on this part are also real condition (SPN 94 FMI 1, SPN 100 FMI 0, SPN 110 FMI 0, SPN 110 FMI 1 and more). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Coolant, oil and low-pressure fuel sensors codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 13

This source lists SPN 100 FMI 1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.