EF Logo

Deutz · Coolant, oil and fuel sensors

Deutz Fault Code SPN 110 FMI 3

Engine - Coolant temperature sensor - Voltage above normal or shorted to high source

What does Deutz code SPN 110 FMI 3 mean?

The EMR4 reads the coolant temperature sensor (in the coolant outlet housing on the cylinder head) at a voltage above its valid window. Urgency: check soon - the machine may derate or limit a function. Check first: with the sensor unplugged and key on, check the signal pin for battery voltage, which would mean a short to supply.

FaultCheckSPN 110FMI 3Deutz · Coolant, oil and fuel sensors
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With the sensor unplugged and key on, check the signal pin for battery voltage, which would mean a short to supply

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 4 done

Causes

  • Open circuit: broken wire, pushed-out pin or an unplugged connector at the coolant temperature sensor
  • Signal wire touching a supply voltage somewhere in the harness
  • Coolant seeping along the sensor body into the connector

How it failed

You'll notice: Warning lamp or a dead temperature display.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant, oil and low-pressure fuel sensors

5 other codes on this part are also shorted high (SPN 94 FMI 3, SPN 97 FMI 3, SPN 100 FMI 3, SPN 175 FMI 3 and more). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Coolant, oil and low-pressure fuel sensors codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 3

This source lists SPN 110 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.