EF Logo

Deutz · Coolant, oil and fuel sensors

Deutz Fault Code SPN 97 FMI 3

Engine - Water in fuel sensor - Voltage above normal or shorted to high source

What does Deutz code SPN 97 FMI 3 mean?

The EMR4 reads the water in fuel sensor (in the fuel pre-filter or water separator bowl) signal above its valid range. The probe circuit is open or pulled up to supply. Urgency: check soon - the machine may derate or limit a function. Check first: unplug the sensor and check the connector for fuel and corrosion.

FaultCheckSPN 97FMI 3Deutz · Coolant, oil and fuel sensors
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Unplug the sensor and check the connector for fuel and corrosion

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 5 done

Causes

  • Open wire or unplugged sensor in the fuel pre-filter
  • Probe corroded or failed open
  • Sensor probe corroded or coated with sludge
  • Water standing in the separator bowl

How it failed

You'll notice: Water in fuel warning or a dead warning lamp.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant, oil and low-pressure fuel sensors

5 other codes on this part are also shorted high (SPN 94 FMI 3, SPN 100 FMI 3, SPN 110 FMI 3, SPN 175 FMI 3 and more). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Coolant, oil and low-pressure fuel sensors codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 7

This source lists SPN 97 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.