EF Logo

J1939 · Lubrication

SPN 100 FMI 1

Oil pressure low, most severe

What does SPN 100 FMI 1 mean?

Oil pressure is far below the safe minimum, the most severe low-pressure level. The ECM may shut the engine down to avoid bearing damage, so stop and check. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level and condition on the dipstick.

FaultStopSPN 100FMI 1J1939 engine ECU
FMI 1
Data below normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop the engine and check the oil level and condition on the dipstick

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Oil level very low or the oil badly diluted with fuel or coolant
  • Oil pump worn or its relief valve stuck open
  • Bearings badly worn, letting oil escape
  • Pickup tube blocked or loose, so the pump draws air

How it failed

You'll notice: Oil pressure is far below the safe minimum, the most severe low level, so the ECM can shut the engine down to save the bearings.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 100 with FMI 1. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.