EF Logo

J1939 · Lubrication

SPN 100 FMI 18

Oil pressure low, moderately severe

What does SPN 100 FMI 18 mean?

Oil pressure is below its limit at the moderately severe level. The engine keeps running but the lamp and derate warn that oil pressure is falling. Urgency: stop now - shut down and fix before working on. Check first: check the oil level and grade against the maker's chart.

FaultStopSPN 100FMI 18J1939 engine ECU
FMI 18
Below normal, moderately severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the oil level and grade against the maker's chart

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Oil level low or the wrong oil grade for the temperature
  • Oil filter plugged or its bypass valve stuck
  • Oil pump or bearings starting to wear
  • Oil cooler restricted

How it failed

You'll notice: Oil pressure is below its limit at the moderately severe level.

Real conditionRead from FMI 18: below normal, moderately severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 100 with FMI 18. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.