EF Logo

J1939 · Lubrication

SPN 100 FMI 3

Oil pressure sensor voltage high

What does SPN 100 FMI 3 mean?

The oil pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return.

FaultCheckSPN 100FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Open signal wire between the oil pressure sensor plug and the ECM, so the input floats to the top of its range
  • Open return, or the signal wire touching the 5 V reference or a battery-voltage circuit
  • Wrong replacement sensor with a different output range from the one the ECM expects
  • Oil wicking up the sensor wires and into the connector, bridging the signal to the supply
1 more cause
  • Sensor body cracked or its thread leaking oil onto the plug

How it failed

You'll notice: The oil pressure gauge reads zero, sticks at the top or flickers and the warning lamp may come on.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 100 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.