EF Logo

J1939 · Lubrication

SPN 100 Fault Code

Engine oil pressure

What does SPN 100 mean?

Pressure in the main oil gallery, read by a sensor on the engine block. The ECM uses it for the gauge and for low-pressure warnings, derates and shutdown. How urgent it is depends on the FMI after SPN 100 - pick it below. Check first: fit a mechanical gauge at the sensor port: if the gauge shows normal pressure while the service tool reads full scale, the fault is electrical.

FaultActiveSPN 100FMI --J1939 engine ECU
SPN 100
Engine oil pressure
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 100 - pick it below.

What should I check first?

Fit a mechanical gauge at the sensor port: if the gauge shows normal pressure while the service tool reads full scale, the fault is electrical

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 100?

You'll notice: The oil pressure gauge reads zero, sticks at the top or flickers and the warning lamp may come on.

Find the number shown after SPN 100 on your display. 4 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

How urgent SPN 100 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Signal high or open: broken or backed-out pin, an open sensor return, or the signal shorted to the 5 V reference at the oil pressure sensor
  • Signal low or shorted: signal wire grounded, or the 5 V reference lost, so the oil pressure sensor reads at the bottom of its range
  • Real condition: low oil level, thinned oil or a worn pump leaving real pressure below the limit
  • Real condition: oil filter or cooler restricted, or a relief valve stuck open
1 more cause
  • Sensor: oil-soaked connector seal letting the signal change as the engine shakes

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 100 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.