J1939 · Lubrication
SPN 4811 Fault Code
Piston cooling oil pressure
What does SPN 4811 mean?
Pressure of the oil that feeds the piston cooling jets. How urgent it is depends on the FMI after SPN 4811 - pick it below. Check first: compare the sensor reading with a mechanical gauge at the same port.
- SPN 4811
- Piston cooling oil pressure
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 4811 - pick it below.
What should I check first?
Compare the sensor reading with a mechanical gauge at the same port
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 4811?
You'll notice: Low pressure risks overheating the pistons, so the ECM may derate or stop the engine.
Find the number shown after SPN 4811 on your display.
- 1SPN 4811 FMI 1: Piston cooling oil pressure is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 3SPN 4811 FMI 3: Piston cooling oil pressure signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, Volvo D13
- 5SPN 4811 FMI 5: Current in the Piston cooling oil pressure circuit is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
How urgent SPN 4811 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Sensor failed
- Jet supply restricted
- Piston cooling valve stuck closed
- Low oil level
Other Lubrication codes
Source
Mack MP8 2010-2013 fault code list (Diesel Laptops)
This list names SPN 4811 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Mack MP7, Mack MP8, Volvo D13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
