EF Logo

Cummins · Lubrication - SPN 100 FMI 18

Cummins Fault Code 143

Engine oil pressure low - moderately severe

What does Cummins code 143 mean?

The oil rifle pressure is lower than expected at the current speed. This is the earlier warning before the most severe level. Urgency: check soon - the machine may derate or limit a function. Check first: check the oil level and condition on the dipstick with the engine off and level.

FaultCheck143Cummins · Lubrication - SPN 100 FMI 18

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the oil level and condition on the dipstick with the engine off and level

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Low oil level or wrong oil grade
  • Oil pump wear or a stuck relief valve
  • Oil filter restriction
  • Oil pressure sensor or circuit fault
1 more cause
  • Bearing wear

How it failed

You'll notice: An amber lamp or oil pressure warning comes on, and a power derate can follow while the oil pressure stays low.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant temperature, oil temperature and oil pressure

Show the other 11 codes
All 20 Coolant temperature, oil temperature and oil pressure codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 143 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 100, FMI 18); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.