EF Logo

Cummins · Lubrication - SPN 100 FMI 1

Cummins Fault Code 415

Engine oil pressure low - most severe

What does Cummins code 415 mean?

The oil pressure at the rifle is below the lowest limit. Continuing to run can wreck bearings quickly. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and check the oil level and condition.

FaultStop415Cummins · Lubrication - SPN 100 FMI 1

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop the engine and check the oil level and condition

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Low oil level or oil diluted with fuel or coolant
  • Oil pump worn or its pickup blocked
  • Oil filter plugged or the bypass valve stuck
  • Worn bearings
1 more cause
  • Oil pressure sensor or its circuit fault

How it failed

You'll notice: A red stop lamp and an audible alarm, and the ECM may shut the engine down after a short delay.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant temperature, oil temperature and oil pressure

1 other code on this part is also lost message (214). When they show together, start at the wiring and connector they share.

Show the other 11 codes
All 20 Coolant temperature, oil temperature and oil pressure codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 415 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 100, FMI 1); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.