EF Logo

Bobcat · Engine

Bobcat Fault Code M0815

Engine coolant temperature shutdown

What does Bobcat code M0815 mean?

The controller shut the engine down because coolant temperature reached the protection limit. Urgency: stop now - shut down and fix before working on. Check first: inspect hoses, radiator seams and the water pump for leaks and wet spots.

FaultStopM0815Bobcat · Engine

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Inspect hoses, radiator seams and the water pump for leaks and wet spots

Then 3 more checks
Code shows hereFAULTM0815

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Water pump or belt failure
  • Thermostat stuck closed
  • Blocked radiator or cooler
  • Failed temperature sender reading too high

How it failed

You'll notice: The controller shut the engine down on high coolant temperature.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine oil pressure, coolant and air temperature

Show the other 19 codes
All 28 Engine oil pressure, coolant and air temperature codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0815 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.