EF Logo

Volvo/Mack · MID 144 vehicle ECU

Volvo/Mack Fault Code MID 144 PPID 312 FMI 0

Air dryer regeneration air flow too high

What does Volvo/Mack code MID 144 PPID 312 FMI 0 mean?

Air flow through the air dryer is too high for it to find time to regenerate, so the dryer cannot clear its desiccant properly between cycles. Urgency: check soon - the machine may derate or limit a function. Check first: check the air filter and the dryer cartridge for damage, corrosion or looseness.

FaultCheckMID 144PPID 312FMI 0Volvo/Mack · MID 144 vehicle ECU
MID 144
Which control unit reports it
PPID 312
Maker parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the air filter and the dryer cartridge for damage, corrosion or looseness

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Air filter
  • Plain air leakage
  • Electronic control system

How it failed

You'll notice: Yellow lamp lit and the air pump ability is reduced because the dryer cannot regenerate.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 36 Vehicle Electronic Control Unit (MID 144) Diagnostic Trouble Code Guide, PV776-88951780

This source lists MID 144 PPID 312 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.