Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 PSID 25 FMI 14
Air leakage - flow too high
What does Volvo/Mack code MID 144 PSID 25 FMI 14 mean?
The air flow is too high at a speed above 50 km/h. The VECU sees an air leak in the air system. Urgency: check soon - the machine may derate or limit a function. Check first: check the air system for leaks with the engine stopped and listen at fittings.
- MID 144
- Which control unit reports it
- PSID 25
- Maker component at fault
- FMI 14
- Special instructions
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the air system for leaks with the engine stopped and listen at fittings
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Air leakage in the brake or suspension air circuit
- Leaking air dryer or purge valve
- Worn air compressor running too much
How it failed
You'll notice: A small leak lights the info lamp and a large leak lights the service lamp.
Real conditionRead from FMI 14: special instructions
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 SID 230 FMI 7Idle validation switch 1 reads wrong
- MID 144 SID 231 FMI 2SAE J1939 data link intermittent or not acknowledged
- MID 144 SID 240 FMI 2VECU program memory checksum error
- MID 144 SID 243 FMI 7Cruise control set switch - SET+ and SET- at the same time
- MID 144 SID 250 FMI 2SAE J1587 data link faulty messages
- MID 144 SID 253 FMI 2VECU calibration memory (EEPROM) checksum error
- MID 144 PPID 265 FMI 3Vehicle speed sensor supply too high
- MID 144 PPID 265 FMI 4Vehicle speed sensor supply too low
Related on Equipments Finder
Source
This source lists MID 144 PSID 25 FMI 14 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
