Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 SID 243 FMI 7
Cruise control set switch - SET+ and SET- at the same time
What does Volvo/Mack code MID 144 SID 243 FMI 7 mean?
The VECU receives the SET+ and SET- signals at the same time, which cannot happen on a good switch. Urgency: check soon - the machine may derate or limit a function. Check first: check the steering column switch connector for damage, corrosion or looseness.
- MID 144
- Which control unit reports it
- SID 243
- Component at fault
- FMI 7
- Mechanical system not responding
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the steering column switch connector for damage, corrosion or looseness
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Faulty harness between the switch and the VECU
- Faulty connector at the steering column
- Faulty cruise control switch
How it failed
You'll notice: Yellow lamp lit and cruise control is deactivated until the SET switch fault is cleared.
Part or controllerRead from FMI 7: mechanical system not responding
The controller reports a part, module or its software as faulty or not responding.
- Meter test
- Check power and ground at the module connector with the key on, then its fuses.
- Good result
- Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 SID 250 FMI 2SAE J1587 data link faulty messages
- MID 144 SID 253 FMI 2VECU calibration memory (EEPROM) checksum error
- MID 144 PPID 265 FMI 3Vehicle speed sensor supply too high
- MID 144 PPID 265 FMI 4Vehicle speed sensor supply too low
- MID 144 PPID 312 FMI 0Air dryer regeneration air flow too high
- MID 144 PSID 2 FMI 7Idle validation switch 2 reads wrong
- MID 144 PSID 25 FMI 14Air leakage - flow too high
- MID 144 PPID 72 FMI 3Pedal and engine brake sensor supply too high
Related on Equipments Finder
Source
This source lists MID 144 SID 243 FMI 7 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
