EF Logo

Volvo/Mack · MID 144 vehicle ECU

Volvo/Mack Fault Code MID 144 SID 253 FMI 2

VECU calibration memory (EEPROM) checksum error

What does Volvo/Mack code MID 144 SID 253 FMI 2 mean?

The data sets stored in the VECU calibration memory (EEPROM) have an incorrect checksum, so some saved parameters are damaged. Urgency: check soon - the machine may derate or limit a function. Check first: reprogram the VECU parameters with the Premium Tech Tool.

FaultCheckMID 144SID 253FMI 2Volvo/Mack · MID 144 vehicle ECU
MID 144
Which control unit reports it
SID 253
Component at fault
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Reprogram the VECU parameters with the Premium Tech Tool

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Faulty EEPROM inside the VECU
  • VECU failure
  • Interrupted parameter programming

How it failed

You'll notice: Yellow lamp lit and some functions may be deactivated until the parameters are restored.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 36 Vehicle Electronic Control Unit (MID 144) Diagnostic Trouble Code Guide, PV776-88951780

This source lists MID 144 SID 253 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.