Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 PID 152 FMI 12
VECU number of resets - internal fault
What does Volvo/Mack code MID 144 PID 152 FMI 12 mean?
The vehicle ECU reset itself because of an internal software fault. The VECU is the faulty component. Urgency: check soon - the machine may derate or limit a function. Check first: check battery voltage and the power and ground at the VECU connector.
- MID 144
- Which control unit reports it
- PID 152
- Parameter at fault
- FMI 12
- Bad intelligent device or component
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check battery voltage and the power and ground at the VECU connector
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Internal software fault causing a reset
- Low supply voltage to the VECU
- VECU failure
How it failed
You'll notice: The system restarted, usually with a short loss of VECU functions and a lit lamp.
Part or controllerRead from FMI 12: bad intelligent device or component
The controller reports a part, module or its software as faulty or not responding.
- Meter test
- Check power and ground at the module connector with the key on, then its fuses.
- Good result
- Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 PSID 2 FMI 7Idle validation switch 2 reads wrong
- MID 144 PSID 25 FMI 14Air leakage - flow too high
- MID 144 PPID 72 FMI 3Pedal and engine brake sensor supply too high
- MID 144 PPID 72 FMI 4Pedal and engine brake sensor supply too low
- MID 144 PID 84 FMI 2Vehicle speed signal incorrect or intermittent
- MID 144 PID 84 FMI 5Vehicle speed sensor open circuit or shorted to ground
- MID 144 PID 84 FMI 6Vehicle speed sensor current high or shorted across sensor
- MID 144 PID 91 FMI 3Accelerator pedal position signal high
Related on Equipments Finder
Source
This source lists MID 144 PID 152 FMI 12 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
