EF Logo

Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)

Volvo/Mack Fault Code MID 128 PPID 348 FMI 9

Inlet NOx sensor signal missing

What does Volvo/Mack code MID 128 PPID 348 FMI 9 mean?

The engine ECM lost communication with the inlet NOx sensor ahead of the SCR catalyst. The sensor control unit is not talking to the ECM. Urgency: check soon - the machine may derate or limit a function. Check first: check the inlet NOx sensor connector and its lock.

FaultCheckMID 128PPID 348FMI 9Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
MID 128
Which control unit reports it
PPID 348
Maker parameter at fault
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the inlet NOx sensor connector and its lock

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Inlet NOx sensor unplugged or connector corroded
  • NOx sensor control unit failed
  • Wiring fault between the control unit and the engine ECM

How it failed

You'll notice: MIL and yellow lamp lit.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: NOx sensors before and after the SCR

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PPID 348 FMI 9 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.