EF Logo

Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)

Volvo/Mack Fault Code MID 128 PPID 270 FMI 9

Outlet NOx sensor signal missing

What does Volvo/Mack code MID 128 PPID 270 FMI 9 mean?

The engine ECM lost communication with the outlet NOx sensor, which sits after the SCR catalyst. Mack lists the loss of the link between the NOx sensor's own control unit and the ECM. Urgency: check soon - the machine may derate or limit a function. Check first: check the outlet NOx sensor connector for water, melted pins and a loose lock.

FaultCheckMID 128PPID 270FMI 9Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
MID 128
Which control unit reports it
PPID 270
Maker parameter at fault
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the outlet NOx sensor connector for water, melted pins and a loose lock

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Outlet NOx sensor unplugged, wiring broken or connector corroded
  • NOx sensor control unit failed
  • Low or unstable supply voltage to the NOx sensor

How it failed

You'll notice: MIL and yellow lamp lit.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: NOx sensors before and after the SCR

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PPID 270 FMI 9 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.