J1939 · Aftertreatment - SCR/DEF
SPN 5745 Fault Code
Aftertreatment diesel exhaust fluid dosing unit heater
What does SPN 5745 mean?
The heater in the DEF dosing unit that keeps its pump and lines from freezing. The aftertreatment control switches it based on temperature. How urgent it is depends on the FMI after SPN 5745 - pick it below. Check first: check the dosing unit heater fuse and relay with the key on.
- SPN 5745
- Aftertreatment diesel exhaust fluid dosing unit heater
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5745 - pick it below.
What should I check first?
Check the dosing unit heater fuse and relay with the key on
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5745?
You'll notice: The DEF dosing unit heater is faulty, so the dosing unit may not thaw after a cold night and dosing will be late.
Find the number shown after SPN 5745 on your display.
- 2SPN 5745 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15
- 3SPN 5745 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, PACCAR MX-13
- 4SPN 5745 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, PACCAR MX-13
- 18SPN 5745 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5745 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Heater circuit open or shorted: broken wire, corroded plug or chafed lead at the dosing unit
- Heater element inside the dosing unit has failed
- Heater relay or fuse faulty, so the heater never gets power
- Dosing unit temperature sensor wrong, so the control switches the heater off too early
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5745 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
