EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 5862 Fault Code

SCR intermediate gas temperature

What does SPN 5862 mean?

Temperature of the exhaust gas between the SCR stages, used in dosing and heat-up control. How urgent it is depends on the FMI after SPN 5862 - pick it below. Check first: compare the reading with the other exhaust temperature sensors on a warm engine.

FaultActiveSPN 5862FMI --J1939 engine ECU
SPN 5862
SCR intermediate gas temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 5862 - pick it below.

What should I check first?

Compare the reading with the other exhaust temperature sensors on a warm engine

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 5862?

You'll notice: The controller may restrict dosing or hold regeneration because it cannot see temperature in the middle of the SCR system.

Find the number shown after SPN 5862 on your display.

  • 0SPN 5862 FMI 0: SCR intermediate gas temperature is above the normal range, most severe levelReal conditionCummins ISX15
  • 2SPN 5862 FMI 2: SCR intermediate gas temperature data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15
  • 3SPN 5862 FMI 3: SCR intermediate gas temperature signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15
  • 4SPN 5862 FMI 4: SCR intermediate gas temperature signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15
  • 14SPN 5862 FMI 14: Special-instruction fault for the SCR intermediate gas temperature; the maker lists a dedicated procedure for itOtherCummins ISX15
  • 16SPN 5862 FMI 16: SCR intermediate gas temperature is above the normal range, moderately severe levelReal conditionCummins ISX15
  • 19SPN 5862 FMI 19: Network data received for the SCR intermediate gas temperature is in errorLost messagePACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 5862 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Sensor probe contaminated
  • Lead heat-damaged
  • Connector corrosion
  • Sensor failed

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 5862 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15, PACCAR MX-13; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.