EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3031 Fault Code

Aftertreatment 1 DEF tank temperature

What does SPN 3031 mean?

Temperature of the DEF in its tank, read by a sensor in the tank module. The aftertreatment control uses it to decide when to heat or thaw the fluid. How urgent it is depends on the FMI after SPN 3031 - pick it below. Check first: compare the DEF tank temperature with ambient after an overnight soak; a stuck value points to the sensor or wiring.

FaultActiveSPN 3031FMI --J1939 engine ECU
SPN 3031
Aftertreatment 1 DEF tank temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3031 - pick it below.

What should I check first?

Compare the DEF tank temperature with ambient after an overnight soak; a stuck value points to the sensor or wiring

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3031?

You'll notice: The DEF tank temperature is misread, so the ECM may heat the tank at the wrong time or not at all.

Find the number shown after SPN 3031 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3031 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Reads cold: an open circuit or a short to supply in the DEF tank temperature sensor wiring, which the ECM reads as an extremely low temperature
  • Reads hot: signal wire shorted to ground or the DEF tank temperature sensor element shorted, which the ECM reads as an extremely high temperature
  • Real condition: tank heater not warming the fluid, so the real temperature stays low in cold weather
  • Real condition: heater coolant supply restricted or valve stuck closed
1 more cause
  • Sensor: dEF crystals on the sender pins making the reading drift with temperature

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3031 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.