J1939 · Aftertreatment - SCR/DEF
SPN 5743 Fault Code
Aftertreatment selective catalytic reduction temperature sensor module
What does SPN 5743 mean?
The module that gathers SCR-area exhaust temperature sensors and reports them to the ECM. Its health decides whether those temperature signals are trusted. How urgent it is depends on the FMI after SPN 5743 - pick it below. Check first: check the SCR module plug for white crystals and green corrosion, then measure its supply and ground.
- SPN 5743
- Aftertreatment selective catalytic reduction temperature sensor module
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5743 - pick it below.
What should I check first?
Check the SCR module plug for white crystals and green corrosion, then measure its supply and ground
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5743?
You'll notice: The temperature module for the SCR catalyst has failed or lost communication, so the ECM cannot see catalyst temperatures and may hold back DEF dosing.
Find the number shown after SPN 5743 on your display.
- 3SPN 5743 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, PACCAR MX-13
- 4SPN 5743 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, PACCAR MX-13
- 9SPN 5743 FMI 9: Abnormal update rate: the signal or message is late or missingLost messageCummins ISX15
- 11SPN 5743 FMI 11: A fault exists but the ECM cannot identify its causeOtherCummins ISX15
- 12SPN 5743 FMI 12: Bad intelligent device or componentPart or controllerCummins ISX15
- 16SPN 5743 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5743 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Supply or ground fault at the SCR-side module plug from DEF-eaten terminals or a lost ground
- CAN pair between the module and the ECM open, shorted or noisy
- Module damaged by DEF corrosion or exhaust heat
- Probe leads from the module to the catalyst damaged, loose or crystal-covered
1 more causeFewer causes
- Module software or configuration not matching the ECM after replacement
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5743 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
