J1939 · Aftertreatment - SCR/DEF
SPN 4364 Fault Code
Aftertreatment SCR catalyst conversion efficiency
What does SPN 4364 mean?
How much NOx the SCR catalyst removes, calculated from inlet and outlet NOx readings. It is used to detect a worn catalyst, poor DEF or a dosing fault. How urgent it is depends on the FMI after SPN 4364 - pick it below. Check first: check the DEF level and test the concentration with a refractometer.
- SPN 4364
- Aftertreatment SCR catalyst conversion efficiency
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 4364 - pick it below.
What should I check first?
Check the DEF level and test the concentration with a refractometer
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 4364?
You'll notice: The SCR is not removing as much NOx as it should, so the ECM sets an efficiency fault.
Find the number shown after SPN 4364 on your display. 3 of them have their own page with causes and checks.
- 1SPN 4364 FMI 1: SCR NOx conversion efficiency is very lowReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 14SPN 4364 FMI 14: SCR efficiency is degraded, or NOx after the catalyst is changing too slowlyOtherPACCAR MX-13
- 17SPN 4364 FMI 17: SCR NOx conversion efficiency is lowReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 18SPN 4364 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15
- 19SPN 4364 FMI 19: The SCR conversion efficiency message arrived in error over CANLost messagePACCAR MX-13
- 31SPN 4364 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 4364 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Poor DEF: wrong, diluted or old fluid, or an empty tank
- DEF doser blocked or crystallised, or a DEF line leak, so too little fluid is injected
- NOx sensors faulty or contaminated, giving a false efficiency reading
- Catalyst aged, damaged or contaminated, or an exhaust leak before the sensor
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 4364 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
