J1939 · Aftertreatment - SCR/DEF
SPN 4364 FMI 1
SCR NOx conversion efficiency very low
What does SPN 4364 FMI 1 mean?
The SCR is removing very little NOx, the most severe level. The ECM can derate and then limit road speed until the cause is fixed. Urgency: stop now - shut down and fix before working on. Check first: check the DEF level and add DEF if the tank is low.
- FMI 1
- Data below normal, most severe
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check the DEF level and add DEF if the tank is low
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- No DEF being injected because the tank is empty or the pump has failed
- Wrong liquid in the DEF tank
- Failed or contaminated catalyst
- Blocked dosing valve or frozen DEF line
How it failed
You'll notice: The SCR removes very little NOx, the most severe level, so the ECM derates and then limits road speed until the cause is fixed; the SCR lamp is on.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4364 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 4364 with FMI 1. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
