J1939 · Aftertreatment - SCR/DEF
SPN 5246 Fault Code
Aftertreatment SCR operator inducement severity
What does SPN 5246 mean?
The current stage of the emissions inducement strategy that warns the driver and then derates or limits speed when SCR faults are ignored. The ECM broadcasts it to the dash and other modules. How urgent it is depends on the FMI after SPN 5246 - pick it below. Check first: check the DEF level and refill with the correct DEF.
- SPN 5246
- Aftertreatment SCR operator inducement severity
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5246 - pick it below.
What should I check first?
Check the DEF level and refill with the correct DEF
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5246?
You'll notice: The ECM has started operator inducement because of an aftertreatment problem, so engine power or road speed is limited.
Find the number shown after SPN 5246 on your display. 2 of them have their own page with causes and checks.
- 0SPN 5246 FMI 0: Value is above the normal range, most severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13
- 14SPN 5246 FMI 14: An aftertreatment system malfunction has been detectedOtherPACCAR MX-13
- 15SPN 5246 FMI 15: Value is above the normal range, least severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 16SPN 5246 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5246 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Empty or low DEF tank
- Poor quality or wrong DEF
- SCR system fault such as a blocked doser, a failed NOx sensor or a failed catalyst
- Tampering or a disconnected sensor in the aftertreatment system
Other Aftertreatment - SCR/DEF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5246 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
