EF Logo

Bobcat · Operator presence

Bobcat Fault Code 11‑05

Seat bar sensor short to battery

What does Bobcat code 11-05 mean?

The seat bar sensor circuit is shorted to supply, so lift/tilt and traction can lock out. Lift, tilt and traction may lock out because the controller cannot confirm the operator is seated. Urgency: check soon - the machine may derate or limit a function. Check first: look inside the plug for water and corrosion that could bridge two pins.

FaultCheck11-05Bobcat · Operator presence

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Look inside the plug for water and corrosion that could bridge two pins

Then 3 more checks
Code shows hereFAULT11-05

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Sensor wire rubbed against a supply wire
  • Harness pinched at the seat bar pivot
  • Seat bar sensor plug wet or corroded
  • Sensor failed internally

How it failed

You'll notice: Lift, tilt and travel will not work correctly because the seat bar sensor circuit is tied to the supply.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Seat bar, press to operate, cab door and door lock

3 other codes on this part are also shorted high (M5202, M5305, H7902). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Seat bar, press to operate, cab door and door lock codes on one page

Source

Bobcat S205 Operation & Maintenance Manual, service codes (flash count table)

This source lists 11-05 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Older Bobcat skid-steer and track loaders using the two-digit service codes (S205 manual, similar models).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.