EF Logo

Bobcat · Operator presence

Bobcat Fault Code M1121

Seat bar sensor out of range high

What does Bobcat code M1121 mean?

On loaders the seat bar sensor signal reads above its valid range, and lift, tilt and traction may lock out. On excavators this code refers to the console sensor. Urgency: check soon - the machine may derate or limit a function. Check first: check the signal at the seat bar sensor plug with the key on; it should sit within the normal 0.5-4.5 V span and never at full supply.

FaultCheckM1121Bobcat · Operator presence

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the signal at the seat bar sensor plug with the key on; it should sit within the normal 0.5-4.5 V span and never at full supply

Then 5 more checks
Code shows hereFAULTM1121

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Short to supply or to the 5 V reference wire on the signal wire at the seat bar sensor plug
  • Broken return or ground wire at the seat bar sensor
  • Pushed-back pin or wet connector at the sensor
  • Internal failure of the seat bar sensor that pegs it high
1 more cause
  • Seat bar pivot wearing the sensor lead

How it failed

You'll notice: The controller reads the seat bar sensor above its valid electrical range and flags it.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Seat bar, press to operate, cab door and door lock

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M1121 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.