Bobcat · Operator presence
Bobcat Fault Code M1122
Seat bar sensor out of range low
What does Bobcat code M1122 mean?
The seat bar (or excavator console) sensor reads below its valid range, so the controller may think the bar is up and keep lift and traction locked. Urgency: check soon - the machine may derate or limit a function. Check first: look for green corrosion, pushed-back pins or a missing seal inside the seat bar sensor plug.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Look for green corrosion, pushed-back pins or a missing seal inside the seat bar sensor plug
Then 5 more checksWhere this code shows
On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.
Checks
0 of 6 done
Causes
- Failed seat bar sensor reading low
- Loose or unplugged seat bar sensor connector
- Lost 5 V reference wire at the seat bar sensor, or a broken signal wire
- Seat bar pivot wearing the sensor lead
1 more causeFewer causes
- Signal wire grounded where the harness runs through the harness at the seat bar pivot, which flexes with every use
How it failed
You'll notice: The seat bar sensor reads under its valid range and the controller sets the fault.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Seat bar, press to operate, cab door and door lock
- B1095-16Window sensor out of range lowOtherCheck soon
- B1095-17Window sensor out of range highOtherCheck soon
- B1095-95Window sensor failureOtherCheck soon
- M1121Seat bar sensor out of range highOtherCheck soon
- M1122Seat bar sensor out of range lowOtherCheck soon
- M1128Seat bar sensor failureErratic or implausibleCheck soon
- M5202Press to operate switch error onShorted highCheck soon
- M5221Press to operate switch out of range highOtherCheck soon
- M5222Press to operate switch out of range lowOtherCheck soon
Show the other 15 codesHide the other codes
- C10B0-00Workgroup disabled due to window faultOtherCheck soon
- 11-05Seat bar sensor short to batteryShorted highCheck soon
- 11-06Seat bar sensor short to groundShorted lowCheck soon
- B1080-09Seat bar failureOtherCheck soon
- B1080-16Seat bar out of range lowOtherCheck soon
- B1080-17Seat bar out of range highOtherCheck soon
- B1090-00Door openOtherCheck soon
- B1091-16Door sensor out of range lowOtherCheck soon
- B1095-13Window sensor open circuitOpen circuitCheck soon
- M5305Press to operate light short to batteryShorted highCheck soon
- M5306Press to operate light short to groundShorted lowCheck soon
- H7902Door unlock error onShorted highCheck soon
- M7902Forestry door closedOtherInformation
- H7903Door unlock error offShorted lowCheck soon
- M7974Door openOtherCheck soon
Other Bobcat codes: Operator presence
Related on Equipments Finder
Source
Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)
This source lists M1122 and its meaning. The guidance on this page is general, not taken from it.
The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
