Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 PSID 230 FMI 4
VECU software reset from low supply voltage
What does Volvo/Mack code MID 144 PSID 230 FMI 4 mean?
The VECU software reset without control. Mack lists a loss or interruption of supply voltage in the wiring harness or faulty software. Urgency: check soon - the machine may derate or limit a function. Check first: check battery voltage and the VECU power and ground.
- MID 144
- Which control unit reports it
- PSID 230
- Maker component at fault
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check battery voltage and the VECU power and ground
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Wiring harness (loss or interruption of supply voltage)
- Faulty software
- VECU failure
How it failed
You'll notice: Yellow lamp lit and the VECU reboots, so there is a brief loss of VECU functions.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 PSID 25 FMI 14Air leakage - flow too high
- MID 144 PPID 72 FMI 3Pedal and engine brake sensor supply too high
- MID 144 PPID 72 FMI 4Pedal and engine brake sensor supply too low
- MID 144 PID 84 FMI 2Vehicle speed signal incorrect or intermittent
- MID 144 PID 84 FMI 5Vehicle speed sensor open circuit or shorted to ground
- MID 144 PID 84 FMI 6Vehicle speed sensor current high or shorted across sensor
- MID 144 PID 91 FMI 3Accelerator pedal position signal high
- MID 144 PID 91 FMI 4Accelerator pedal position signal low
Related on Equipments Finder
Source
This source lists MID 144 PSID 230 FMI 4 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
