EF Logo

Volvo/Mack · MID 144 vehicle ECU

Volvo/Mack Fault Code MID 144 PSID 204 FMI 9

Data link lost - brake control module (ABS)

What does Volvo/Mack code MID 144 PSID 204 FMI 9 mean?

The VECU did not receive the expected messages from the brake control module (ABS) on the J1939 CAN 1 link. Urgency: check soon - the machine may derate or limit a function. Check first: check the ABS ECU in the scan tool; no response means power, ground or the CAN wires.

FaultCheckMID 144PSID 204FMI 9Volvo/Mack · MID 144 vehicle ECU
MID 144
Which control unit reports it
PSID 204
Maker component at fault
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the ABS ECU in the scan tool; no response means power, ground or the CAN wires

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • CAN 1 link between the VECU and the ABS ECU down or shorted
  • VECU set to expect high-resolution wheel speed (HRW) from the ABS that the ABS is not sending
  • ABS ECU not powered or in a fault state

How it failed

You'll notice: Yellow lamp lit and the VECU loses wheel speed from the ABS, which can disturb speed-based functions and traction features.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Brake and steering faults are a safety issue on site. Chock the machine and keep it parked until the fault is found and the brakes are tested.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 36 Vehicle Electronic Control Unit (MID 144) Diagnostic Trouble Code Guide, PV776-88951780

This source lists MID 144 PSID 204 FMI 9 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.