Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 PPID 312 FMI 0
Air dryer regeneration air flow too high
What does Volvo/Mack code MID 144 PPID 312 FMI 0 mean?
Air flow through the air dryer is too high for it to find time to regenerate, so the dryer cannot clear its desiccant properly between cycles. Urgency: check soon - the machine may derate or limit a function. Check first: check the air filter and the dryer cartridge for damage, corrosion or looseness.
- MID 144
- Which control unit reports it
- PPID 312
- Maker parameter at fault
- FMI 0
- Data above normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the air filter and the dryer cartridge for damage, corrosion or looseness
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Air filter
- Plain air leakage
- Electronic control system
How it failed
You'll notice: Yellow lamp lit and the air pump ability is reduced because the dryer cannot regenerate.
Real conditionRead from FMI 0: data above normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 PSID 2 FMI 7Idle validation switch 2 reads wrong
- MID 144 PSID 25 FMI 14Air leakage - flow too high
- MID 144 PPID 72 FMI 3Pedal and engine brake sensor supply too high
- MID 144 PPID 72 FMI 4Pedal and engine brake sensor supply too low
- MID 144 PID 84 FMI 2Vehicle speed signal incorrect or intermittent
- MID 144 PID 84 FMI 5Vehicle speed sensor open circuit or shorted to ground
- MID 144 PID 84 FMI 6Vehicle speed sensor current high or shorted across sensor
- MID 144 PID 91 FMI 3Accelerator pedal position signal high
Related on Equipments Finder
Source
This source lists MID 144 PPID 312 FMI 0 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
