EF Logo

Volvo/Mack · MID 144 vehicle ECU

Volvo/Mack Fault Code MID 144 PID 91 FMI 4

Accelerator pedal position signal low

What does Volvo/Mack code MID 144 PID 91 FMI 4 mean?

The pedal position sensor signal is below about 0.4 V, which the VECU treats as an abnormally low voltage or a short to a lower voltage. Urgency: check soon - the machine may derate or limit a function. Check first: read the pedal value in the scan tool as you press the pedal; a flat reading near zero confirms the fault.

FaultCheckMID 144PID 91FMI 4Volvo/Mack · MID 144 vehicle ECU
MID 144
Which control unit reports it
PID 91
Parameter at fault
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the pedal value in the scan tool as you press the pedal; a flat reading near zero confirms the fault

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Accelerator pedal position harness shorted low
  • Faulty accelerator pedal position sensor
  • Lost sensor signal wire

How it failed

You'll notice: Yellow check lamp lights and the engine will not supply the fuel the pedal requests, so throttle response is limited.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Accelerator pedal position

1 other code on this part is also shorted low (MID 144 PID 91 FMI 6). When they show together, start at the wiring and connector they share.

All 4 Accelerator pedal position codes on one page

Source

Mack Group 36 Vehicle Electronic Control Unit (MID 144) Diagnostic Trouble Code Guide, PV776-88951780

This source lists MID 144 PID 91 FMI 4 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.