EF Logo

Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake

Volvo/Mack Fault Code MID 128 PSID 98 FMI 0

Turbocharger boost pressure too high

What does Volvo/Mack code MID 128 PSID 98 FMI 0 mean?

The turbocharger boost pressure is higher than the ECM wants. Mack lists a failed EGR system, a faulty outlet pressure sensor or turbo surge. Urgency: check soon - the machine may derate or limit a function. Check first: compare boost with the commanded value under load in the scan tool.

FaultCheckMID 128PSID 98FMI 0Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake
MID 128
Which control unit reports it
PSID 98
Maker component at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Compare boost with the commanded value under load in the scan tool

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • EGR system failure
  • Faulty turbocharger outlet pressure sensor
  • VGT nozzle stuck closed

How it failed

You'll notice: MIL lamp lit and possible turbo surge noise.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Turbo boost pressure control

1 other code on this part is also real condition (MID 128 PSID 98 FMI 1). When they show together, start at the wiring and connector they share.

All 2 Turbo boost pressure control codes on one page

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PSID 98 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.