EF Logo

Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake

Volvo/Mack Fault Code MID 128 SID 27 FMI 2

Variable geometry turbo actuator - no valid command received

What does Volvo/Mack code MID 128 SID 27 FMI 2 mean?

The variable geometry turbocharger (VGT) smart actuator has not seen a valid command on the CAN 2 data link, so it cannot position the nozzle as the ECM asks. Urgency: check soon - the machine may derate or limit a function. Check first: read the VGT actuator status and position in the scan tool; no response points at the data link or power.

FaultCheckMID 128SID 27FMI 2Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake
MID 128
Which control unit reports it
SID 27
Component at fault
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the VGT actuator status and position in the scan tool; no response points at the data link or power

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Damaged CAN 2 harness or connector to the VGT actuator
  • No supply or ground at the VGT actuator
  • VGT smart remote actuator failed
  • Engine ECM not sending the command

How it failed

You'll notice: Boost is low, power drops and you may see smoke.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Variable geometry turbo actuator

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 27 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.