Komatsu · Engine controller
Komatsu Fault Code B@BCNS
Engine coolant overheating
What does Komatsu code B@BCNS mean?
The engine coolant temperature went above the limit. Keep running and the head can crack or the gasket blow, so stop the engine and let it idle down first. Urgency: stop now - shut down and fix before working on. Check first: let the engine idle to cool, then check the coolant level when it is safe to do so.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Let the engine idle to cool, then check the coolant level when it is safe to do so
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- Low coolant level or leak
- Blocked radiator or oil cooler fins
- Fan drive or belt not working
- Failed thermostat
1 more causeFewer causes
- Failed temperature sensor
How it failed
You'll notice: Coolant overheat warning on the monitor with B@BCNS.
Shorted highRead from how the source describes the code
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine fluid, filter and temperature warnings
2 other codes on this part are also shorted high (B@HANS, CA428). When they show together, start at the wiring and connector they share.
- B@BAZGEngine oil pressure lowOtherStop now
- B@BAZKEngine oil level lowOtherCheck soon
- B@BCNSEngine coolant overheatingShorted highStop now
- B@BCZKEngine coolant level lowLost messageCheck soon
- B@HANSHydraulic oil overheatingShorted highStop now
- AA10NXAir filter cloggedReal conditionCheck soon
- CA428Water in fuel sensor: high voltageShorted highCheck soon
- CA429Water in fuel sensor: low voltageShorted lowCheck soon
- CA435Engine oil pressure switch errorOtherCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)
This source lists B@BCNS and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
