EF Logo

JLG · Electrical

JLG Fault Code 441

Battery voltage too low - system shutdown

What does JLG code 441 mean?

Battery voltage dropped below about 9 V and the system shuts down. The operator sees the machine die or refuse to start, often when cranking. Urgency: stop now - shut down and fix before working on. Check first: measure battery voltage at rest and while cranking; charge or replace the battery if it falls sharply.

FaultStop441JLG · Electrical

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Measure battery voltage at rest and while cranking; charge or replace the battery if it falls sharply

Then 4 more checks
Code shows hereFAULT441

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Flat or failing battery that collapses under cranking load
  • Poor battery terminal or main ground connection
  • Alternator failed so the battery drains while running
  • Heavy parasitic load or a short drawing the battery down
1 more cause
  • Corroded or damaged main power cable

How it failed

You'll notice: The system shuts down because battery voltage fell below about 9 V; the machine dies or will not start, especially under starter load.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery, contactors, starting, generator, lights and alarm outputs

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 441 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.