EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3364 Fault Code

Aftertreatment 1 diesel exhaust fluid quality

What does SPN 3364 mean?

A measure of the DEF concentration and condition, from a quality sensor in the tank or inferred from NOx. The aftertreatment control uses it to catch diluted or wrong fluid. How urgent it is depends on the FMI after SPN 3364 - pick it below. Check first: check the DEF sample against clean DEF with a refractometer; good fluid with a quality fault points to the sensor or its circuit.

FaultActiveSPN 3364FMI --J1939 engine ECU
SPN 3364
Aftertreatment 1 diesel exhaust fluid quality
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3364 - pick it below.

What should I check first?

Check the DEF sample against clean DEF with a refractometer; good fluid with a quality fault points to the sensor or its circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3364?

You'll notice: The ECM cannot judge DEF quality, so it may warn of poor fluid and then start inducement, with a lamp and derate even if the fluid is good.

Find the number shown after SPN 3364 on your display. 3 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3364 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Signal high or open: open signal or return wire, or the signal touching a supply wire, at the DEF quality sensor
  • Signal low or shorted: signal wire grounded, or the supply to the DEF quality sensor lost
  • Real condition: diluted or contaminated DEF that really is poor quality
  • Real condition: wrong fluid in the tank after a top-up
1 more cause
  • Sensor: air bubbles or sloshing in the tank giving a noisy quality reading

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3364 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.