J1939 · Aftertreatment - SCR/DEF
SPN 3364 FMI 4
DEF quality sensor voltage low
What does SPN 3364 FMI 4 mean?
The DEF quality sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the DEF quality sensor live with the key on; if it sits at its minimum straight away the fault is steady.
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the DEF quality sensor live with the key on; if it sits at its minimum straight away the fault is steady
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal circuit grounded inside the harness between the DEF quality sensor and the ECM
- No supply at the DEF quality sensor because the supply wire is broken or shared with another failed part
- Sensor lead rubbed through against the tank strap or heater line and grounded
- DEF spill over the sensor plug at the last top-up, bridging signal and return
1 more causeFewer causes
- Diluted or wrong fluid that really reads poor quality on a healthy sensor
How it failed
You'll notice: The ECM cannot judge DEF quality, so it may warn of poor fluid and then start inducement, with a lamp and derate even if the fluid is good.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3364 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3364 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
